|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
| Magnets, pads, cables ... | |
 |
Measurement pads enable the fixing of an accelerometer to a machine surface. Secure mounting is the only way to ensure the repeatability of measurements. It is important for trend data and also for high frequency measurements. |
| Download: Data sheet pads | |
| A3914 Connection box | |
 |
Module A3914 is used for signal connection between measurement points with difficult access and a measurement instrument. The A3914 provides connection of several sensors to one place, which simplifies route measurement. The IP65 housing provides protection in wet and dusty environments. The Adash 3914 Connection Box can be used for up to 4 accelerometers. Each accelerometer is connected to BNC connector on the front panel. The box is protected by IP 65 and is simply installed by 3 screws or on DIN rail. |
| Download: Data sheet A3914 | |
| A3915 ICP power supply | |
 |
Adash 3915 power supplies ICP sensors. On the output is AC signal in aprox. +/-6V range without DC. |
| Download: Data sheet A3915 | |
| A4800Trig trigger generator | |
 |
This unit is invaluable to any consultant or service engineer who has to use different sources for tacho input signals. These tacho signals are frequently not TTL – sometimes just pulse strings or distorted or of a lower voltage than the vibration instrument can handle. The A4800 will generate a corresponding TTL signal from any input, which exceeds an adjustable threshold level. The presence of a trigger output is indicated by a flashing yellow LED. |
| © Adash 2010 |